What if All U.S. Toilets were flushed at the same time? BOOM The end of the world as we know it?
Apparently there would be a few noticeable challenges such as an apartment building that might backup a bit. There would be a few issues but it would not be the end of the toilet world as we know it.
Since water is being held in the tank pre-flush, the bigger problem would be refilling the tanks all at once. All the low water pressure, it might take a bit of time.
Live Science wrote this post referencin Michael Johnson, a civil engineer at the Utah Water Research Laboratory. For the whole TOO MUCH IMFORMATION TMI Article check it out here.
No More Toilet Overflows,
No More High Water Bills
Because of Leaks and Stuck Open Flappers!
NO WATER HITS THE FLOOR WITH THE TOILET GUARDIAN!
WE STOP THE $$$ LOSS WHEN LEAKS OCCUR !!!
The Toilet Guardian is an electronic water valve that reads the changing water levels in the tank and bowl then shuts off the water to the toilet when a problem is detected.
It only takes minutes to install. Simply turn off the water to the toilet, remove the fill line from the fill valve, attach the Toilet Gurdian to the fill valve, reattach the fill line, turn the water back on and your toilet is operational again. Next install the small bowl sensor to the seat bolt for overflow protection. Last hang the tank sensor in the tank for leak detection and you are ready to start saving money and protecting your property. In under 10 minutes your protection is complete.
The system comes in three models:
1. TG 1000 A -offers complete protections including bowl overflow elimination and water conservation
2. TG 1000 B – bowl overflow elimination only.
3. TG 1000 T – water conservation and leak detection only.
Go right to the AquaOne Library to download and view Toilet Guardian Install Specification Sheets. Guides, User Manuals, Videos and more are also available for viewing and downloading.